FiltersDone

Question type

Essay

Multiple Choice

Short Answer

True False

Matching

Exam 12: Fillet Welds

Show Answer

Share

---

All types

Filters

Study Flashcards

Question 1

Multiple Choice

Review LaterAdd Note

Review Later

When the ____ symbol is used, a length dimension is not needed.

A) weld-all-around
B) weld-around
C) weld-full
D) weld-completely

E) All of the above
F) B) and C)

Correct Answer

verified

Show Answer

Question 2

Multiple Choice

Review LaterAdd Note

Review Later

The ____ weld is one of the most widely used types of welds.

A) fillet
B) fill
C) filling
D) filled

E) None of the above
F) A) and C)

Correct Answer

verified

Show Answer

Question 3

True/False

Review LaterAdd Note

When a general note covers the size of fillet welds, the dimension does not usually appear on the welding symbol.

Intermittent welding consists of a series of ____ welds.

____________________ intermittent welding means that the welds appear directly opposite each other on the two sides of the joint.

____ lines are used as terminal points for the section lining.

If the fillet weld symbol has unequal legs, the size of each leg is indicated in ____ at the left of the weld symbol.

The fillet wield symbol is always drawn so that the ____________________ leg is to the reader's left.

Specific lengths of fillet welds can be described by placing the symbols in conjunction with the ____ lines of the drawing.

Only the fillet weld symbol may be used in combination with other symbols.

If a fillet is shown on both sides of the joint, it is identified as a(n) ____________________ fillet weld.

Each short weld in intermittent welding is called a(n) ____.

In a fillet weld symbol, the two legs are assumed to be equal in size unless otherwise specified.

A(n) ____________________ represents length of weld.

The size of a fillet weld refers to the length of the ____ of the weld.

Fillet welds must always have equal legs.

Extension and ____ lines are occasionally used with the welding symbol to locate the desired welds.

The center-to-center distance, in inches or millimeters of each increment, is the ____.

If the length of the weld is specified, it is placed on the immediate left of the weld symbol.

When a length is not specified on the welding symbol, the fillet weld is assumed to be ____________________.